Squeak in clutch area 1200 Sport

I've noticed that when the bike is off, either hot or cold, that when squeezing the clutch lever quickly, it squeaks. The sound is coming from the throwout bearing/arm side, not the  lever. There is no hanging up or impingement, and there is no noise squeak when the lever is pulled slowly, and it has that nice dual plate ring when pulled while running. Something to just watch? This is the dual plate on the 1100 GRiSO, so figured I'd ask here. WG can be a pain sometimes.

Mine squeaks too, but not very loud and it is only on release, not when pulled in.
I'm not going to worry about mine.

normal...

Perhaps it's the clevis pin in the lever arm? On occasion, they can corrode in there. Slacken off the cable, pull the split pin (I replace split pins with R clips) and check the state of the clevis pin - polish up with wet 'n dry & machine oil if dirty, replace and test again.

MalG wrote:

Perhaps it's the clevis pin in the lever arm? On occasion, they can corrode in there. Slacken off the cable, pull the split pin (I replace split pins with R clips) and check the state of the clevis pin - polish up with wet 'n dry & machine oil if dirty, replace and test again.

Is a Hydro clutch. All mechanical parts are interior, just the fluid line to the slave. Thanks though!

There is no binding, just a squeak when pulling and releasing the lever quickly.cNo issues when running or riding, just figured I'd ask as it is very similar to the GRiSO 1100.

Simply can't be heard while your engine is running. Mine does it "sometimes" - remember it's all spring loaded and sometimes "groans" when actuated.

mmm have heard my 1200 Pumper do it once or twice....
maybe its the fluid protesting as it is "quickly" forced through an oriface???