Leaking clutch master cylinder cover on 16'

Hello All,

Any advice on how to stop the cover from seeping?  I actually already replaced the boot and cover thinking that would solve the issue, but no.  Also, I removed some of the fluid but it's still happening.  Dumb question #2: Does the "min" line on the housing reflect the minimum amount of fluid with the cover/boot on or off?  Maybe there is just too much fluid?

[You must be registered and logged in to see this image.]" />

Thanks!

Take a bit more fluid out. As long as it covers the priming port it's fine but you don't want it too low or it will uncover the port as the pads wear.

Pete

Thanks Pete, I'll extract a bit more fluid tomorrow and see if that does the trick. Appreciate the response-
Chris