Broken Guzzi Stand wheel

Managed to break the wheel on the stand today whilst 'fiddling around' with wheels....Interested if anyone else has solved this one as my experience so far:
- no guzzi Oem spares for the stand I can find?
- skateboard wheels are 22mm internal w/out bearing; 8mm with bearing so would need some work to fit (8mm bolt I don't think so) & not sure their compressive strength anyway ?
- Lots of cheap plastic stuff but have stated load max of 25 kg range so likely self destruct under 220kg bike
- ordered the ones below with 150 kg load each but will need to trim the axle width with the lathe to get back to original bolts (else need longer bolts)

[You must be registered and logged in to see this image.]

These 150kg wheels should do the job Paul, good find!

Just posting result as guide for anyone who gets the same problem with OEM stand. These wheels did the trick - although did need to angle grind them down to width of the old axle & drill out the centres to take the old spacers. Good thing with slightly bigger wheels is the stand lifts bike bit higher but still easy to use.

[You must be registered and logged in to see this image.]

Nice job Paul