MRA highway shield questions

So I just installed a MRA universal highway shield on my GRiSO. I'm looking for input from anybody that has experience with this. It seems a lot of area to expose to the wind with sustained travel at 100 mph( I live in the Southwest). I'm wondering about the durability of this with what I deem a minimal amount of bracketry/bracing. Other than that I like the looks of it. It seems almost invisible from 40 ft away and the dark tint at the bottom hides the gauges and was very easy to install. Easily removed to install my Puig when the weather gets over 105.

Hi wrrhe,

I don't see your pic. Is there one?

I don't have one but more braces are usually better.

I see a couple of "universal" MRA screens on Revzilla. Which one do you have?

Yes I got it from revzilla and here's a picture of it with the installation kit installed SKU: 1038676
I'll get a picture of the bike with it on tomorrow.

I've run a PUIG Custom II screen (pic below) that is 18.5 inch high and has same brackets as MRA (or is yours higher than this ??) - in fact the original PUIG brackets were so basic (looked like local blacksmith had made them from cast iron), I bought MRA Universal bracket kit and swapped it onto the PUIG screen.  Just have to make sure you tighten it fully at all points & then no problems ever - even at stupid high speeds - & the wind protection is noticeably  better than the Guzzi screen.[You must be registered and logged in to see this image.]

Just FYI I looked back through emails & mine is this screenPUIG C2 with this bracket system MRA uni brackets.

The PUIG brackets don't fit unless you use M6x15mm bolts & ditch the bracket covers...MRA bracket fits perfect.

Paul,Your setup looks very similar to mine so if you haven't had any problems with yours I shouldn't have any with mine. Thanks
[You must be registered and logged in to see this image.]